Gingerbread Wall Hangers Instructions

PLEASE NOTE: 

You will need to sew out the main gingerbread first then mark and center to sew out the banner with black  strings. This applies if you plan to sew out on fabric (not Free Standing)

Second Option: Sew the designs out as individual units and then assemble with black ribbon as shown in the photos. The names are added to photos as an idea for you. These would be cute with you kids name for the Christmas tree. I used the Angelina Font available here.

Back To Ginger Wall Hangers

Instructions:

To Sew Out as Free Standing 

1. Hoop three sheets of WSS alternating the grain for each sheet hooped. 

2. Sew out each design piece.. 

3. Remove the design from hoop. 

4. Trim excess WSS. Rinse in warm water leaving about 25% of the WSS intact. 

5. Lay flat to dry between two sheets of paper sack or paper towel. 

When completely dry place inside a piece of fabric and gently press with a hot iron. 

Then assemble the hanging using ribbon. 

You will need to hot glue the ribbon to the star but the heart has a little loop built in. 

You will need to pierce the black holes to insert the ribbon through.. Have fun.,

Basically look at the filled design that is sewn out on fabric to get an idea of how to insert the ribbon.